Ozeki 10 SMS Gateway

SMPP server performance tuning

If you operate an SMPP server, you will often be faced with the requirement to optimize for performance, or just simply to limit the message throughput for a particular SMPP user account. You may also want to limit the incoming message rate, and you might have to limit the speed at which you pass messages to a certain SMS service providers on SMPP client connections. The following documents give information on how to tune message throughput on SMPP server systems.



smpp speed test
How to measure SMPP performance
This document present a test system where an SMPP client is connected to an SMPP server. In this test system the messages come from a tester user, who is able to generate test messages and they end up in a tester connection instead of going to the mobile network. See how you can use the Ozeki SMS Gateway to reach SMPP throughput speeds up to 1000 Messages per Second (MPS).
Learn more about SMPP speed testing
smpp client
How to set an incomign speed limit for an SMPP user
This document shows you all the configuration steps that you have to perform in the SMPP User connection to set a new Speed limit. With this manipulation you are able to slow down your message processing in that case if your Service provider is can not handle the sending speed that your license allows.
Learn more about limiting smpp speed for users
how to setup an smpp server
How to limit outgoing speed on an SMPP service provider connection
This document shows you all the configuration steps that you have to perform in the SMPP Client connection to set a speed limit. With the settigns shown you are able to slow down your message sending. This can be a requirement by your SMS service provider in case they cannot handle the sending speed that your license allows.
Learn more about limiting speed on smpp client connections